Envirocare - Commercial Installation

Connecting a property to a Envirocare treatment system couldn't be easier. To give you an insight into what is involved, we have included a selection of photographs of a typical commercial installation. In this instance, a P100 unit serving a 100-person equivalent application.

1. A mechanical digger excavates the hole, sized to accommodate the specific unit. The location is generally as far as possible from the dwelling and is carefully selected to adhere to regulatory requirements.

Step 1

2 & 3. Straight from the factory, your treatment system is delivered and unloaded directly to where you need it -anywhere in Ireland

Step 2

Step 3

4.With the connecting pipework channels dug, the treatment system can be lowered into the ground. The unit's inlet and outlet orientation are clearly marked and the tank is easily lifted on its supplied lifting eyes.

A concrete base is required for the unit to be sited upon. This serves not only to give it a secure footing, but also to counter the natural hydraulic pressure from sites with high water tables.

Step 4

5. Ensuring the unit is straight and level is an imperative. (The treatment system can be installed into recessed areas, but measures must be taken to ensure that the unit is not flooded by surface water run-off).

Once located on the concrete base, the unit is filled with water, while concrete is simultaneously backfilled around the plant. This is to balance inward and outward pressures to the chamber and to avoid any chance of flotation.

The inlet and outlet connections are made and the air blower pipe is connected to the main unit. (The air blower unit itself is located on it's own concrete slab and can be positioned up to 15m from the main tank).

Electrical connections to the air blower unit are buried in armoured conduit and the remaining trenches are filled and landscaped. The unit is now ready for immediate use.

Step 5